[Marco]

Hi to all
i have upgraded slide2 from "outside" wall to "inwall" :-D
and add "RGB LED Strip für Flächenbündige Einbaudose" code GES.EBC.FLE.5101 as DE_myGEKKO Produktkatalog.pdf pag 89.

due to painter's work :-( red and green cable was removed from dmxdirver, i tray to look image in to Produktkatalog.pdf but is too small. someone can check if conncetion on photo are correct?

then i have pick up +24v from slide2, green connector 24VDC and GND, and connet to DCIN+/- on dmxdriver the 1st one on left. there are + - + - on dc in , can't see difference :-(
is this correct ?

Thanks
Marco

[finnerhofer]

Hey Marco,

in the Link you can find the technical manual i think you can see there the right connection.

https://transfer.my-gekko.com/f.php?h=71...277&mail=1

Grüße
Fabian

[Marco]

Thankyou so much ! Hope DC in 1e2 as the same as 3&4. i will try. jus see i had red and blu issue. good.

(there are, emh, "few" manual in italian (or english) that i miss, emh, "lot")

[finnerhofer]

Hi Marco,

yes its the same.

you are right, i think but these will be added soon.

Grüße
Fabian

[Marco]

and done :-D

thanks again